What are the specific functions of sealing AB silicone? What are the steps to smoothly pour the sealing AB silicone?

Sealing ab silicone can be used in many industries, which can directly penetrate the gap and play the effect of filling and potting. When the first potting effect is not ideal, the second or even third potting can be performed after the adhesive layer is cured, which greatly improves the potting effect. So, how to complete the pouring?

Treatment of sealed base surfaces

Before the formal pouring, don't forget to clean the base surface. Clean the dust, rust, and oil on the base surface, and use chemicals or tools to clean up if necessary. Make sure the base surface is clean and tidy and not wet, so as not to affect the bonding effect.

Reasonable configuration of sealing ab silicone

Before the formal pouring, it is necessary to configure the AB group materials according to the scientific proportion and mix them evenly. According to the specific demand to deploy, to avoid the waste of materials. Generally speaking, the prepared materials should be used up within two hours, otherwise, the viscosity of the materials will increase with time, which will directly affect the fluidity and increase the difficulty of construction. When carrying out this step, it is necessary to pay attention that the material should not be too much, so as not to cause waste. For materials that have not been mixed temporarily, they should be sealed in time to avoid affecting secondary use.

Do a good job of checking for gaps

After pouring, allow it to cure in an environment protected from sun, wind, and rain. Wait until after 24 or 48 hours to check how the cure is. Check to see if there are any omissions, and do a good job of checking for omissions. To ensure a lasting effect, it is recommended that customers use high-quality adhesives, cooperate with powerful suppliers, and be more assured.

These are the three steps of pouring sealing ab silicone, and none of them are indispensable. Choose a high-quality adhesive and follow the steps above, which can play a role in waterproof, moisture-proof, anti-corrosion, and aging resistance, without worrying about the pouring effect.